Table of Contents
Advertisement
The Rack Mount Adaptor AG-M730-E is used to mount the unit on the IEC standard rack.
Installation of the AG-M730-E
7.
Remove the 4 screws
from the side cabinet of the unit.
2.
Use the 4 screws supplied
with the AG-M730-E to install to the unit.
Install it with the
notch down
Mounting on the IEC standard rack
7.
Remove the 4 rubber legs
from the bottom of the unit.
IEC standard rack
ee
j
Fasten
it to the
rack with
2.
Mount the unit on the rack.
ess
W@ Be sure to install a ventilation fan (air volume of about
3.3 m 2/sec.) on the top of the rack.
Installation of slide rails
@ Use a complete slide rail and bracket unit for 457 mm length (part
No. CC3004-99-0017) or 610 mm length (part No. CC3004-99-
0018) of Chassis Track. (The complete slide rail and bracket unitis
©
not available from Panasonic.)
Slide rail
@ When using the slide rail, remove the setscrews. The setscrews
ae
can be removed by pulling in the direction of the arrow. Keep
« 4
ie)
the removed setscrews, washers and spacers in a proper place.
e
For the details, contact your authorized service personnel.
Setscrew
re
Washer
Spacer
— £-58 -
Advertisement
Table of Contents
