Table of Contents
Advertisement
When an error appears on the counter display, it means that a malfunction has occurred in the unit. When this
happens, terminate operation without delay and remedy the trouble by following the instructions in the Instruction
Manual.
.!/
F
Leave power on and wait until error display is
Li
Condensation
cleared (see MEMO below).
Ie tae se
Malfunction in elevator | This occurs when the cassette has not been
4
4
section
inserted properly. Turn off the power and switch it
a
|
Malfunction in loading | back on again, and check that the unit operates
La
-!
section
normally.
Cow
Malfunction in cylinder
4
:
section
This occurs when a heavy load is applied because
an os
Malfunction in reel
condensation has formed on the tape or for some
La
-!
section
other reason. Turn off the power and switch it back
a
a
Malfunction in tension | on again, and check that the unit operates normally.
o
er
section
an
Malfunction in
Turn off the power and switch it back on again, and
o
'
solenoid section
check that the unit operates normally.
*
Contact your authorized dealer if the unit does not function normally when the above remedial action has been taken.
MEMO
Condensation
This phenomenon is caused by the same principle under which droplets of moisture (condensation) form on a
window in a heated room when it is cold outside. It can occur when the unit or a tape is moved a location with a
significantly different temperature or humidity. It also occurs:
¢
When the unit or tape is moved to a location full of steam which cannot escape or a location with a high humidity,
or immediately after movement to a heated room
¢
When the unit or tape is moved quickly from a cold or cooled location to a high-temperature and/or high-humidity
location
SHOULD
A MALFUNCTION
OCCUR,
TURN
OFF THE
POWER
IMMEDIATELY,
TAKE HOLD OF THE POWER
PLUG AND DISCONNECT IT FROM
THE POWER
SOCKET
AND
CONTACT
YOUR
DEALER.
CONTINUED
USE
MAY
CAUSE
FURTHER DETERIORATION OR LEAD TO AN ACCIDENT.
— E-54-
Advertisement
Table of Contents
