–
Apply pressure to the spring with your thumb.
–
2
Mount pin
I00080-10
–
Mount the washer and splint
–
Repeat these steps on the opposite side.
I00081-10
–
Position the left frame protector.
–
Insert the right frame protector from below and push it to the
rear.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount the cable ties.
I00084-10
–
Remove the seat. (
–
Connect positive cable
Guideline
Screw, battery termi-
nal
–
Connect negative cable
Guideline
Screw, battery termi-
nal
Contact disks
cable sockets
nal.
–
Slide positive terminal cover
–
Charge the 12-V battery. (
Guideline
The 12-V battery must be fully charged before it is handed
over to the customer.
I00083-11
Info
The first charging process may take longer with a new
12-V battery.
.
3
.
4
with the washers.
M5
3 Nm (2.2 lbf ft)
p. 13)
5
to the 12-V battery.
M5
2.5 Nm
(1.84 lbf ft)
6
to the 12 V battery.
M5
2.5 Nm
(1.84 lbf ft)
C
must be mounted under screws
8
with the claws toward the battery termi-
9
over the positive terminal.
p. 14)
SETUP 2
7
and
7