DIN Front-mount
Installation with the rubber bush
i e
¥S
1.Dashboard
i 3
eos
i a z
Holder
)
:
After inserting the holder into the dash-
3.Rubber bush
4.Screw
RO
Removing the unit
7.Frame
2.insert the release pin into the hole in the
bottom of the frame and pull out to remove
the frame.
(When reattaching the frame, point the side
with a groove downwards and attach it.)
3.Lever
~
Insert the levers supplied with the unit into
a
the grooves at both sides of the unit as
shown in figure until they click. Pulling the
levers makes it possible to remove the unit
from the dashboard.