Advertisement
QUICK START GUIDE
For the LGX® PRO METAL
CONNECTION
Do not connect a LGX® PRO METAL stepper motor to a printer's cable without checking the wires and pins of the connection cable. Not
all printers are ready for a direct connection with the motor. Some use stepper drivers with no protection and this may damage them.
Before connecting a LGX® PRO METAL to any 3D printer
check if the connector pins are wired as shown below:
Position 0
Load or unload filament
without pressure from
the drivegears.
www.bondtech.se
Position 1
For rigid materials.
After start of service, if the LGX® PRO METAL is turning in the
wrong direction, swap the top (or bottom) pair of wires.
Position 2
For harder rigid
materials, when you
need more grip. Or for
semi-flexibles >95A.
Position 3
For flexible materials
softer than 95A.
Position 4
For very flexible
materials softer than
85A.
Page 3/8
Advertisement
