Table of Contents
Advertisement
Front panel: The temperature status for the front of the
BladeCenter unit.
Event log
Select this choice to view entries that are currently stored in the
management module event log. This log includes entries for events
that are detected by the blade servers. The log displays the most
recent entries first. Information about all remote access attempts is
recorded in the event log, and the management module sends out
the appropriate alerts if configured to do so.
You can sort and filter entries in the event log.
LEDs Select this choice to view the state of the BladeCenter system LED
panel and blade server control panel LEDs. You also can use this
choice to turn off the information LED and turn on, turn off, or blink
the location LED on the BladeCenter unit and the blade servers.
v Front Panel LEDs - The state of the following LEDs on the
BladeCenter system LED panel. You can change the state of the
information and location LEDs.
– Information
– System error
– Over temperature
– Location
v Blade Server LEDs - The state of the following LEDs on the
blade server control panel. You can change the state of the
information and location LEDs.
– Power
– Information
– Error
– Location
– Keyboard, video, and monitor select
– Media (CD-ROM, diskette drive, USB port) select
Hardware VPD
Select this choice to view the hardware vital product data (VPD) for
the BladeCenter unit. When the BladeCenter unit is started, the
management module collects the vital product data and stores it in
nonvolatile memory. The management module then modifies the
stored VPD as components are added to or removed from the
BladeCenter unit. You can access this information at any time from
almost any computer.
Firmware VPD
Select this choice to view the vital product data (VPD) for the
firmware in all blade servers and the switch modules and
management module in the BladeCenter unit. The firmware VPD
identifies the firmware type, build ID, release date, and revision
number. The VPD for the firmware in the management module
includes the file name of the firmware components. (Selecting this
choice takes 3 to 4 minutes to refresh and display information.)
Blade tasks
Select the choices in this section to view and change the settings or
configurations of blade servers in the BladeCenter unit.
Chapter 4. Configuring your BladeCenter unit
47
Advertisement
Table of Contents
