Advertisement
Manual tightening function
1. With the switch at off, the bit is locked in
place, and the tool can be used as a
manual screw-driver (up to 22.5 Nm, 230
kg-cm, 200 in. lbs.).
There will be a little play in the chuck, but
this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque than the
maximum torque of the driver (position
on the clutch), for confirming the
tightness of a screw or for loosening an
extremely tight screw.
@ Reversing lever
(Forward/ Switch lock/Reverse)
CAUTION; Set the main switch at OFF and
wait until the bit has come to a complete stop
before operating this lever.
1.
For reverse rotation, set the lever to
reverse.
Check the direction of rotation before
use.
2.
After use, set the lever at the center
(switch lock) position.
(D) Variable speed control trigger
1.
Depress the trigger slightly to start the
tool slowly.
2. The speed increases with the amount of
depression of the trigger for efficient
tightening of screws and drilling. The
brake operates when the trigger is
released
and
the
chuck
stops
immediately.
Note:
When the brake operates, a braking
sound may be heard.
This sound indicates engagement of
the bit lock.
• Do not lock the tool (motor).
This may cause damage to the unit.
(E) Speed selector switch
Choose a tow or high speed to suit the use.
'
EY6101/EYS100
EY6181
Torque
LOW 50' 350min-'(RPM) 50 ' 350 min •' (RPM) Strong
HIGH 180'1300 min ''(RPM) 150- 1000min '(RPM)
Less
CAUTION; Check the speed selector switch
before use.
0 Bit holder
Remove the battery pack to expose the bit
storage compartment inside the handle
I
housing.
A bit up to 50 mm, 1-31/32 long can be
i
stored here.
© Battery pack
ATTENTION;
The product that you have purchased
contains a rechargeable battery.
The battery is recyclable. At the
end of its useful life, under various
state and local laws, it may be illegal to
dispose of this battery into the
municipal waste stream.
Check with
your local solid waste officials for
details in your area for recycling
options or proper disposal.
1.
Press the battery pack release buttons
(fi) on both sides and puli the pack
away from the tool.
2. Charge the battery pack using the battery
charger.
3.
After the charging has been completed,
remove the battery pack from the charger
and connect it to the tool. Disconnect the
charger from the power source when not
in use.
Note:
EY9103, EY9101 and EY9182 can
not be recharged with the 1-hour
battery charger EY0001 and RE570.
Advertisement
