Advertisement
FOR BATTERY CHARG¬
ER & BATTERY PACK
„ SAVE THESE IN¬
STRUCTIONS
This
manual contains important safety and
operating instructions for battery chargers
EY0202, EY0001 and RE570.
2} Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack.
3)
CAUTION
- To reduce the risk of
injury, charge only battery pack as shown
below.
RE570
EY970, EY9080, EY9086
Approx. 1 hour
EY0001
EY9001, EY9006
Approx. 1 hour
EY0202
EY9001,EY9080,EY9065
EY9006, EY9086
Approx. 15 min.
EY9101,EY9180, EY9182
EY9103
Approx. 20 min.
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger to rain or snow.
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it wilt
not be stepped on, tripped over, or
otherwise subjected to damage or stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock. If
extension cord must be used, make sure:
a. that pins on plug of extension cord are
the same number, size and shape as
those of plug on charger.
b. that extension cord is properly wired
and in good electrical condition.
c. that wire size is large enough for
ampere rating of charger as specified
below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating.
Amperes
AWG Size of Cord
Equal to or
But less
Length of Cord. Feet
greater than
than
25
50
too
150
0
2
18
18
18
16
8) Do not operate charger with damaged
cord or plug - replace them immediately.
9) Do not operate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified
serviceman.
10) Do not disassemble charger; take it to a
qualified serviceman when service or
repair is required. Incorrect reassembly
may result in a risk of electric shock or
fire.
11) To reduce the risk of electric shock,
unplug charger from outlet before
attempting any maintenance or cleaning.
12) The charger and battery pack are
specifically designed to work together.
Do not attempt to charge any other
cordless tool or battery pack with this
charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the
battery pack housing.
15) Do not store the tool and battery pack in
locations where the temperature may
reach or exceed 122T {50°C) (such as a
metal tool shed, or a car in the summer),
which can lead to deterioration of the
storage battery.
3
Advertisement
