Selecting A Screen - Yamaha S-03SL Owner's Manual

Selecting a Screen

You can switch between screens by using the [▲]/[▼],
[E]/[F], [+]/[–] and [EXIT] buttons.
[▲]/[▼] buttons
Many of the displays consist of different screens. Use
the [▲]/[▼] buttons to select the various screens.
Previous screen (PAGE)
DATA
DEC NO
Next screen (PAGE)
When selecting the various display pages, an arrow
appears at the right of the LCD, indicating the
parameter type in the printed list on the panel.
For example, if the display for the Total Volume
parameter in the Multi Edit mode is called up, the
arrow in the LCD indicates that this parameter belongs
to the General type.
Total Vol
PAGE PART ELEM KEY
2 P
OCTAVE
In the example below, the display for the (Element)
Cutoff parameter in the Voice Edit mode is shown, and
the arrow indicates that this parameter belongs to the
Filter type.
Cutoff
2047
PAGE PART ELEM KEY
13 E
OCTAVE
30
INC YES
VOICE
MIX
GENERAL
127
TONE
CONTROLLER
EFFECT
VOICE OSC MIX
MIX PITCH
GENERAL FILTER
TONE AMP
CONTROLLER LFO
EFFECT EFFECT
[E]/[F] buttons
Some of the display pages have multiple "screens."
These are indicated by special arrow marks in the top
right of the LCD (see below). Use the [E]/[F]
buttons to select these pages.
When the first screen of a mulitple-page set is called up,
the arrow points to the right (fi), indicating further
screens are available. When a page in the middle of the
set is called up, arrows point in both directions (‹ fi),
indicating you can select either the next or previous
screens. When the last screen is called up, the arrow
points to the left (‹), indicating no further screens are
available.
For certain parameters (such as Voice Name, etc.),
these buttons are used to move the cursor position in
the display.
Decay Tm
PAGE PART ELEM
12
OCTAVE
DEC NO
Selects the
previous screen.
[+]/[–] buttons
In the Multi Edit mode, these buttons are used to select
each part. To select the Common parameters, press
both buttons simultaneously. In the Voice Edit mode,
these buttons are used to select each Element. To
select the Common parameters, press both buttons
simultaneously.
PART ELEMENT KEY
COMMON
n For details on the parameters and page configurations of
the Multi Edit and Voice Edit modes, refer to the relevant
mode explanations in the Reference section of this
manual.
+00
KEY
1
DATA
INC YES
Selects the
next screen.
MUTE