Yamaha S-03SL Owner's Manual page 65

15-1. Porta Sw
(Portamento Switch)
15-2. PortaTime (Portamento Time)
Set the Portamento parameters. Portamento creates a
smooth transition from the pitch of the first note
played to the pitch of the next.
Porta Sw
off
PAGE PART ELEM KEY
15 P 1
OCTAVE
■ Porta Sw
Switch Portamento on or off.
❏ Settings: off, on
■ PortaTime
Set the pitch transition time. Higher values result in
longer transition times.
❏ Settings: 0~127
16. PB Range (Pitch Bend Range)
Set the amount (in semitones) by which the pitch of
the note is varied when you move the Pitch Bend wheel
up/down. For example, if you set a value of +12,
moving the wheel up raises the pitch by a maximum of
octave.
PB Range
PAGE PART ELEM KEY
16 P 2
OCTAVE
❏ Settings: –24~+24
17. MW FltCtl (MW Filter Control)
Set the depth of control of the Modulation wheel over
the filter cutoff frequency.
MW FltCtl
PAGE PART ELEM KEY
17 P 1
OCTAVE
❏ Settings: –64~+63
PortaTime
000
PAGE PART ELEM KEY
15 P 1
OCTAVE
+02
+00
18-1. MW PMod
(MW Pitch Modulation Depth)
18-2. MW FMod
(MW Filter Modulation Depth)
18-3. MW AMod (MW Amplitude
Modulation Depth)
These parameters let you set the depth of control the
Modulation wheel has over the pitch, filter and
amplitude modulation of the Voice.
MW PMod
010
PAGE PART ELEM KEY
18 P 1
OCTAVE
MW AMod
000
PAGE PART ELEM KEY
18 P 1
OCTAVE
❏ Settings: 0~127
■ MW PMod
Set the amount by which the pitch modulation
changes when the Modulation wheel is used. The
larger the setting, the greater the depth of control.
(The vibrato effect becomes deeper.)
■ MW FMod
Set the amount by which the filter Cutoff frequency
changes when the Modulation wheel is used. The
larger the setting, the greater the depth of control.
(The wah effect becomes deeper.)
■ MW AMod
Set the amount by which the amplitude modulation
changes when the Modulation Wheel is used. A
larger setting produces greater modulation depth.
(The tremolo effect becomes deeper.)
n Depending on the selected LFO wave type and the
amplitude modulation depth setting, noise may result
when the controller is moved. If this happens, reduce
the modulation depth value.
MW FMod
000
PAGE PART ELEM KEY
18 P 1
OCTAVE
65
Part Controller