Table of Contents
Advertisement
I
13. The drive clutch control cable is attached to
the deck. Attach the cable to the lever in the
clutch control housing, located in the middle
of the upper handle, as follows,
a.-Place the lead ball end of the cable into the
fitting provided in the end of the clutch
control lever. Slip the braided wire into the
-vertical slot as shown in figure 7.
FIGURE 7.
Slide the
braided wire around
in
the
horizontal slot. See figure 8.
Place the plastic fitting on the control
cable into the first adjustment position in
the clutch control housing. See figure 7.
Secure the plastic cap (E) to the clutch con¬
trol housing using the two Phillips head
screws (D). See figure 8.
| warningJ
Drive clutch adjustment must be
checked before the unit is operated,
as described in the operation sec¬
tion.
FIGURE 8.
14. The three speed shift cable is attached to the
drive clutch control housing on the upper han¬
dle. Attach the shifting mechanism on the
other end of the cable to the three speed hub
assembly as follows.
a. Place the three speed shift lever in the
third speed position (all the way down).
b. Insert pin (H) into hub assembly as shown
-in figure 9.
c. Loosen the locking bolt on the mechanism
shown in figure 9 using a 9 mm wrench or
socket.
FIGURE 9.
6
Advertisement
Table of Contents
