Table of Contents
Advertisement
FIGURE 4.
5. The brake cable is attached to the engine.
Route the brake cable under the lower handle.
Place end of cable into the upper hole on the
bottom of the control housing, and through
the slot on the side of the housing as shown.
The angle of the flange on the plastic fitting
must be positioned downward as shown in
— figure 4. Be careful not to bend or kink the
cable.
Ac
WARN*NG
The cable must be assembled as
shown for proper blade brake opera¬
tion.
FIGURE 5.
Lever on Engine
FIGURE 6.
6. Snap the plastic fitting on the end of the cable
into the control housing.
7. Hook the "Z" end of the brake cable into the
—hole in the brake control handle. See figure 5.
8. Place the throttle control lever on the handle
forward until it stops in "Fast" position.
(Do
not
push all the way forward to "Choke" posi¬
tion.) See figure 6.
9. The throttle control cable is attached to the
upper handle. Hook the "Z" end of the throttle
control cable into the hole in the control lever
on the engine. See figure 6.
10. Loosen the screw on the cable clamp shown
in figure 6. Slip the control casing under the
clamp.
11. Slide the thottle control lever on the engine as
far toward the outside of the engine as it will
-go
easily
as shown in figure 6.
(Do not
force it
into the extreme outside position, which is
the "Choke" position.) Then tighten the screw
to secure the throttle control cable. Be certain
the clamp is positioned so it holds the cable
in a straight line, parallel to the engine
shroud.
12. Loosen the screw on the clamp on the side of
the engine. Secure the cable
away from the
muffler.
Be careful not to bend or kink the
cable. Tighten the screw.
5
Advertisement
Table of Contents
