Speaker Assembly (For Thinkpad E16 Gen 2 Only) - Lenovo ThinkPad E14 Gen 6 User Manual

The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
For access, do the following:
1. Disable the built-in battery. See "Before you replace any CRU" on page 41.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 42.
Step 1. Remove the M.2 solid-state drive as shown below.
Step 2. Install the M.2 solid-state drive in reverse order.

Speaker assembly (for ThinkPad E16 Gen 2 only)

Follow the instructions to replace the base cover assembly.
Before you start, read
Generic Safety and Compliance Notices
and print the following instructions.
Chapter 6
. 45
CRU replacement