Sensor Calibration (For Thinkpad X1 2-In-1 Gen 9 Only) - Lenovo ThinkPad X1 2-in-1 Gen 9 Hardware Maintenance Manual

• Logic card to plastic
Turn an additional angle of 180 degrees after the screw head touches the surface of the logic card.
Notes:
• Ensure that you use the correct screw. It is recommended to use new screws for replacements. If you
have a torque screwdriver, tighten all screws firmly to the torque specified in the screw information table
for each step.
• Ensure torque screwdrivers are calibrated correctly following country specifications.

Sensor calibration (for ThinkPad X1 2-in-1 Gen 9 only)

If your system board or LCD unit has been replaced, do the following to make sensor calibration:
1. Download the Windows Sensor Calibration Tool by following steps:
Note: This Sensor Calibration Tool is limited to Lenovo service providers. You can contact a Lenovo
authorized service provider to have your system board or LCD unit replaced.
a. Go to
https://support.lenovo.com
b. Log in to your Lenovo account on the Lenovo support website.
c. Search for the product name, and then search for the Sensor Calibration Tool on the product page to
download it.
2. Extract the tool into a local driver, such as D:\WinCalibration.
3. Type WindowsCalibrationTool.exe –calibrate a –minimal –updateiss –primaryonly to create a Update.bat
file as shown. Then, copy the file to the same folder of the Windows Sensor Calibration Tool.
4. Run the Update.bat file as Administrator.
5. Lay down the computer with the LCD panel facing up as shown and then follow the on-screen
instructions to start the calibration process.
54
ThinkPad X1 Carbon Gen 12 and ThinkPad X1 2-in-1 Gen 9 Hardware Maintenance Manual
.