Husqvarna LC 251i Operator's Manual page 19

Battery charger
LED on the battery
charger
The error LED flashes
or comes on.
Lawn mower
The warning indicator (error LED) is found below the
battery lid.
Problem Error LED (number
of flashes)
Error LED flash- 3
es. The product
does not operate
correctly.
5
6
10
Error LED flashes. No flashes
The product stops.
3
8
9
15
1
LC 251iS
2207 - 003 - 26.10.2023
Cause
The battery charger is
too cold or too hot to
use.
Other errors.
Cause
The blade is blocked.
The motor speed drops too
much, and the motor stops.
1
The wheels or transmission is
blocked.
The motor control is too hot.
Battery connector failure.
There is overload in the mo-
tor.
The battery is weak.
Battery error or no signal from
battery.
Incorrect start procedure. The
motor brake handle has been
engaged before the motor
starts.
Solution
Let the battery charger cool down or move it indoors to warm
it up. When the battery charger has the correct temperature, it
can be used again. Use the battery charger when the ambient
temperature is 5 °C–40 °C.
Speak to your Husqvarna servicing dealer.
Solution
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
possible obstacles and make sure that
the blade can rotate freely. If the prob-
lem continues, speak to your Husqvarna
servicing dealer.
Increase the cutting height. Refer to
set the cutting height on page 12 .
Turn the safety key to 0 to prevent ac-
cidental start. Remove the battery and
wait a minimum of 5 seconds. Remove
the possible obstacles and make sure
that the wheels can rotate freely. If the
problem continues, speak to your Husq-
varna servicing dealer.
Stop the motor and wait until it has be-
come cool.
Examine the battery connector.
Increase the cutting height. Refer to
set the cutting height on page 12 .
Charge the battery. Refer to
the battery on page 12 .
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes. Refer
to
Release the motor brake handle and
wait approximately 5 seconds. Push the
motor brake handle down again to start
the product.
Battery on page 18 .
To
To
To charge
19