Advertisement
XR-Q150
Cam
plate
MENT METHOD
64
Turn the gear in arrow direction to the front, and move the cam plate
to the front.
When the gear is turned until the cam plate comes to the very frent
position (EJECT position), the CD disc will be pulled out.
p
Remove the spring and two screws, and then remove the disc plate.
Move the cam plate to the very front position (EJECT position).
(Refer to the CD disc manual removal method.)
Remove the spring.
Remove to the front while pulling the claw part of the cam plate to
the outside.
Raise the clamper holder lightly, slide it in arrow direction, and re-
move it. When the centering plate is moved to the rear, the four
screws fixing the servo mechanism become visible. When
these
screws are removed, the servo mechanism assembly can be re-
nepved.
TAN and RAD
adjustment are executed from above with the
clamper holder and the roller holder removed and only the magnet
clamper placed onto the CD disc.
Advertisement
