Advertisement
5 BUNDLE ASSIGNMENT [IN1] and [IN2] Rotary Switches
These switches set the receive bundle number for audio signals to be received over the CobraNet
network. The [IN1] switches specify the receive bundle 1 number, and the [IN2] switches specify
the receive bundle 2 number. Two rotary switches are used to specify each number. See "Bundle
Number Setting Procedure" on page 15 for details.
6 BUNDLE ASSIGNMENT [OUT1] and [OUT2] Rotary Switches
These switches set the transmit bundle number for audio signals to be transmitted over the CobraNet
network. The [OUT1] switches specify the transmit bundle 1 number, and the [OUT2] switches specify
the transmit bundle 2 number. Two rotary switches are used to specify each number. See "Bundle
Number Setting Procedure" on page 15 for details.
■
Circuit-board Switches
7 SERIAL ASSIGNMENT [RX] Rotary Switch
Sets the receive channel for the CobraNet serial control signal from channel 1 through channel 15.
The control signals are received from a device that has been set to the matching transmit-channel
number. No serial control reception occurs if this switch is set to "0".
8 SERIAL ASSIGNMENT [TX] Rotary Switch
Sets the transmit channel for the CobraNet serial control signal from channel 1 through channel
15. The control signals are sent to devices that have been set to the matching receive-channel
number. No serial control transmission occurs if this switch is set to "0".
When adjusting rotary switches please use a screwdriver with a blade that matches the switch
groove. Attempting to use a screwdriver that is too large or too small can damage the switch.
RX
TX
7
8
MY16-C Owner's Manual
9
Advertisement
