Table of Contents
Advertisement
SVM7007 TROUBLESHOOTING AND REPAIR E‐7
Service and repair should be performed only by Lincoln Electric factory trained personnel. Unauthorized repairs
performed on this equipment may result in danger to the technician or machine operator and will invalidate your factory
warranty. For your safety and to avoid electrical shock, please observe all safety notes and precautions detailed
throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact
the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. CALL 400 820 9755
DESCRIPTION
This procedure will aid the technician in the removal and replacement of the Case Covers.
MATERIALS NEEDED
8mm
Wrench
PROCEDURE
1.
Remove the input power to the OPITIMARC® CV/CC500 machine.
2.
Using an 8mm wrench, remove the four screws from the top of the case top and six screws from the both sides of
the case top. See Figure E.1.
3.
Using an 8mm wrench, remove the eight screws from the right case side. See Figure E.2.
4.
Using an 8mm wrench, remove the eight screws from the left case side. See Figure E.3.
5.
Remove the case top, the left case side and the right case side.
CASE COVER REMOVAL
WARNING
FIGURE E.1 ‐ CASE TOP REMOVAL
®
OPTIMARC
CV/CC500
Advertisement
Table of Contents
