Master Control Section - Yamaha MW10 Owner's Manual

Reference
Front & Rear Panels

Master Control Section

1
3
4
8
9
C
1
2TR IN Jacks
These RCA pin jacks can be used to input a stereo sound
source. Use these jacks when you want to connect a CD
player directly to the mixer.
Select where you want to send the signal using the
NOTE
2TR IN/USB switch
using the 2TR IN/USB control in the Master Control
section.
2
REC OUT (L, R) Jacks
These RCA pin jacks can be connected to an external
recorder such as an MD recorder in order to record the same
signal that is being output via the STEREO OUT jacks.
The mixer's STEREO Master control has no affect on
NOTE
the signal output via these jacks. Be sure to make
appropriate level adjustments at the recording
device.
18
MW8CX/MW10C Owner's Manual
2
5
6
7
0
A
B
D
MW8CX
B
, and adjust the signal level
3
RETURN L (MONO), R Jacks
These are unbalanced phone-jack type line inputs. The signal
received by these jacks is sent to the STEREO L/R bus.
These jacks are typically used to receive the signal returned
from an external effect device (reverb, delay, etc.).
These jacks can also be used as an auxiliary stereo
NOTE
input. If you connect to the L (MONO) jack only, the
mixer will recognize the signal as monaural and will
send the identical signal to both the L and R jacks.
4
SEND EFFECT (AUX) Jack
This is an impedance balanced* TRS phone jack that outputs
the signal from the EFFECT (AUX) bus. You can use this
jack, for example, to connect to an external effect unit.
5
STEREO OUT (L, R) Jacks
These are impedance balanced* TRS phone jacks that output
the signals adjusted by the STEREO Master control
can use these jacks, for example, to connect to the power
amplifier driving your main speakers.
6
MONITOR (L, R) Jacks
These are impedance balanced* TRS phone jacks that output
the signals adjusted by the MONITOR/PHONES control
Connect these jacks to your monitor system.
7
PHONES Jack
Connect a pair of headphones to this TRS phone jack. The
PHONES jack outputs the same signal as the MONITOR
OUT jacks.
8
PHANTOM +48 V Switch
This switch toggles phantom power on and off. When the
switch is on the mixer supplies +48V phantom power to all
channels that have XLR mic input jacks (CHs 1–5/6).
Turn this switch on when using one or more phantom-pow-
ered condenser microphones.
When this switch is on the mixer supplies DC +48 V
NOTE
power to pins 2 and 3 of all XLR-type MIC INPUT
jacks.
• Be sure to leave this switch off (
not need phantom power.
CAUTION
• When tuning the switch on (
only condenser mics are connected to the XLR
input jacks (CHs: 1 to 5/6). Devices other than
condenser mics may be damaged if connected
to the phantom power supply. Note, however,
that the switch may be left on when connecting
to balanced dynamic microphones.
• To avoid damage to speakers, be sure to turn
off amplifiers (or powered speakers) before
turning this switch on or off. We also recom-
mend that you turn all output controls (STE-
REO Master control, etc.) to their minimum
settings before operating the switch to avoid
the risk of loud noises that could cause hearing
loss or device damage.
E
. You
C
.
) if you do
), be sure that