6.0 FIRST PREPARATION
To avoid cable damages and wear, make sure to have left the right cable length between the lamp and support
tube, equal to at least 50 linear cm, before assembling the device.
Guarantee the minimum cable curve radius equal to 50 mm to avoid damages.
Secure the steel tube to the base, screwing in the
Make sure the steel tube is well-anchored to the
2 supplied M8 knobs.
base.
Lift the lamp body over the steel tube and slide it
Secure the lamp body at the required height by
inside.
tightening the supplied knob.
9
DPLLAMP01 - ENGLISH