GERATHERM ovu control Instructions For Use Manual page 36

PROCESSING / CLEANING
Note:
• Do not clean the device or the lens under running
water.
• Avoid cleaning the lens with cleaning agents (deter-
gents, soap etc.), as these can leave residues on the
lens that may affect crystallization.
EN
Before starting processing, remove the blue protective cap
from the device. Then carefully remove the lens by pulling it
off the main body.
Clean the lens with a lint-free cloth. If necessary, moisten the
cloth with small amounts of water. Wipe the flat inner side of
the lens two or three times to remove any saliva. The main
body must be cleaned in the same way. Then, wipe the sur-
faces dry with a lint-free cloth.
All components of the Geratherm
ually checked for damage after processing. Do not use the
Geratherm
After cleaning, store the device in a dry, clean and dust-free
location. Always put the protective cap on the device.
30
SN
ovu control if it is damaged.
®
ovu control must be vis-
®