SH-003 - Smoke / Heat Detector High Temp Kit Installation Instructions 1 Overview The SH-003 kit can be used for general smoke / heat detection; however, it is ideal for use in high temperature areas such as engine rooms. The SH-003 kit contains a Smoke/Heat Detector, a Sounder, and an Auxiliary Relay that will interface into a single channel of a Maretron SIM100.
3 Electrical Wiring Note: These wiring instructions show connections to channel 'SW1' of the SIM100; however, connections could be made to other channels of the SIM100 using the same method. The SIM100 can support up to 6 detector areas. 4 Detector Behavior When a detector is triggered or in Test Mode the detector's sounder will sound, the detector base relays will change state, and the integrated Red LED will illuminate solid.
SH-003 - Smoke / Heat Detector High Temp Kit Installation Instructions 5 Configuration Provisioning a SIM100 while connected to the SH-003 Kit requires an initial setup. This setup can be completed using either a Maretron gateway paired with a PC running Maretron’s N2KAnalyzer ®...