Remote Control Transmitter - Yamaha KPA-502 Owner's Manual

With the remote control transmitter provided with this unit,
you can operate the unit at your listening/singing position.
The buttons on the remote control transmitter have the same
functions as those with the identical names on the main unit.
For detailed instructions, refer to the descriptions on the
corresponding buttons on the main unit.
KARAOKE
VCD/LD
Karaoke
MPX/
function buttons
STEREO
KARAOKE
DSS
I
—
VOLUME buttons
+: press to turn
up volume
–: press to turn
down volume
REMOTE CONTROL OPERATION RANGE
6 m
30°

REMOTE CONTROL TRANSMITTER

TAPE AUX
Input selector
buttons
ONE TOUCH
KARAOKE VOCAL AID
BALLAD POPS
KARAOKE DSS
JAZZ ROCK
buttons
È i
DIGITAL KEY
CONTROL buttons
+
VOLUME
REMOTE SENSOR
30°
Battery installation
1
Pull out the battery compartment lid in the direction of
the arrow.
2
Install the batteries (size AA, R6, UM-3) with correct
polarities. Follow the diagram in the compartment.
3
Push the compartment lid in until it clicks into place.
1
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace
both batteries with new ones.
NOTES:
÷ Use only AA, R6, UM-3 batteries for replacement.
÷ Be sure that the polarities are correct. (See the illustration
inside the battery compartment.)
÷ Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
÷ If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
2
3
11