Page 1
KMA-1080/KMA-980 Digital Karaoke Mixing Amplifier OWNER’S MANUAL MANUAL DE INSTRUCCIONES...
Page 2
4 Do not expose this unit to sudden temperature changes from warm. Turn the power off, then leave the unit alone for cold to hot (or vice versa), and do not locate this unit in an cooling. environment with high humidity (i.e. a room with a...
CONTENTS INTRODUCTION HANDLING PRECAUTIONS ......2 BEFORE CONNECTING ........2 PREPARATION NAMES OF PARTS AND THEIR FUNCTIONS ................3 OPERATION SYSTEM CONNECTIONS ........6 CONNECTIONS ............ 7 CONFIGURATION DIAGRAM ......10 REMOTE CONTROL ......... 11 GENERAL OPERATION ........13 SETUP MODE............14 ADDITIONAL INFORMATION TROUBLESHOOTING........
Before using this unit, be sure to read this manual so that you can take full advantage of the features of this unit. After you finish reading, keep this manual in a safe place in case you need it in the future. The manual should be very helpful in understanding the Digital Karaoke Mixing Amplifier and solving any difficulties that may arise during use.
ECHO MODE is reset after the played song has finished E KEY CONTROL when the ECHO MODE auto reset is set to on. Refer to To transpose the key of the played music, rotate this “ECHO MODE auto reset” on page 14. The unit assumes control.
B VIDEO INPUT jacks Connect to the output jacks of a TAPE player, VCR, etc. Connect to the input jack of the video output of a DVD, AUX*, or background video player or video camera, etc. 4 TAPE audio input jacks Connect to the output jacks of a TAPE player, VCR, etc.
Page 7
) is provided for KMA-1080 only. C DVD INPUT LEVEL H Power cable Adjust the balance of the DVD input level with respect to Plug this cable into an AC wall outlet after all other other inputs (AUX*, TAPE, BGM).
System A Active subwoofer Active subwoofer (With lowpass filter) Right Left VTR/LD TAPE Background Power Right Left KARAOKE/ player recorder music/video amplifier DVD player System B (KMA-1080 player (KMA-1080 only) only) The shaded part ( ) is provided for KMA-1080 only.
) is provided for KMA-1080 only. Close the lever to secure the conductor wire. Before connection, strip a section of coating 15 mm (9/16”) in length from the end of each cord using a tool such as pliers. (Low) (High) 15 mm (9/16”)
Page 10
REMOTE External remote control ■ Connecting the RCA pin plugs satellite When connecting RCA pin plugs, be sure to insert the red plug into the red jack and the white plug into the white KMA-1080/ jack. KMA-980 White REMOTE (Direct)
Page 11
1. External remote control satellite Connect to +5V_OUT, REMOTE and GND. Note By connecting the remote control satellite to this input, this unit can receive the signal of the remote control. 2. REMOTE (Direct) Connect to REMOTE (Direct) and GND.
■ Operation of remote control 1. Remote control The distance between the remote control and the remote sensor of this unit should be within 6 m (20’). Be sure to aim the remote control directly at the remote sensor on the front panel.
Page 14
REMOTE CONTROL 2. Loading a battery The life of the battery used in the remote control is about half a year under normal use. Remove the battery if the remote control is not used for an extended period. When the battery becomes weak, replace with a new CR2025 battery.
) is provided for KMA-1080 only. ■ Notes for the proper use of microphones • Sing into the microphone by holding it at a distance of 5 to Connect the required number of 10 cm (2 to 3-15/16”) from your mouth.
Last memory*: The settings when the unit was turned off 9. Power Amplifier mode last are recalled. You can also use this unit as a 2ch power amplifier. Most Preset: The settings saved to PRESET 1 are recalled. of the functions on this unit are not available in Power Amplifier mode.
Page 17
Front&Ext.: 1 Front: 2 Ext.: 3 Disable: 4 6. MIC/MUSIC max –1 No setting: 10 Set to the indicated level: 9 to 3 level Example: 3 Set MIC and MUSIC separately. 7. MIC/MUSIC volume –2 Pattern 1: 1 Pattern 2: 2...
Page 18
SETUP MODE Menu KEY CONTROL Items/MUSIC 9. Power Amplifier –4 Normal: 1 Power Amplifier: 2 mode See the CAUTION on page 17. 10. Initializing –5 Cancel: 1 Initialize: 3...
• Always use the default setting for Power Amplifier mode in normal use. • If “Power Amplifier: 2” is set, the volume level of this unit will be maximum and cannot be controlled by rotating MUSIC on the front panel.
Never use alcohol, thinner, benzene, insecticide or other volatile agents, for they may damage the surface paint or gloss of the set. Also do not wipe the set with a chemical cloth or leave it on the set for a long period, for the surface finish may deteriorate or the paint may be stripped off.
TREBLE ............±10 dB (10 kHz) • Speaker impedance [KMA-1080] 435 (17-1/8”) (1 system only A or B) ......4 Ω to 8 Ω /8 Ω to 16 Ω (2-system operation A and B)........8 Ω to 16 Ω 18 (11/16”) [KMA-980] (1 system only) ............