Digital Audio Setup; Equalizer (Sound Mode); Reverb Mode) - Yamaha DVD-E600 Owner's Manual

Setup Menu

DIGITAL AUDIO SETUP

In this menu, you can set up the digital audio output
signal from the digital jacks, such as coaxial etc.
DIGITAL OUTPUT
1 Press 34 to highlight DIGITAL OUTPUT.
2 Enter its submenu by pressing 2.
3 Press 34 to highlight the selected item.
➜ All: Original digital signals output.
➜ PCM Only: If your receiver is PCM-compatible, or your
receiver can not decode MPEG-2 or Dolby Digital,
choose this option.
4 Press ENTER/OK.
5 Press 1 and return to the Audio Setup Page.
Note: If DIGITAL OUTPUT is set to "ALL", all audio settings
except MUTE are invalid.
LPCM OUTPUT
In this menu, you can select PCM digital output between
48kHz and 96kHz.
1 Press 34 to highlight the "LPCM OUTPUT".
2 Enter its submenu by pressing 2.
3 Move the cursor by pressing 34 to highlight the selected
item.
➜ 48K: 96kHz (if available on disc) PCM data stream will
be converted to 48kHz.
➜ 96K: If the 96kHz disc is copy protected, the digital
output will be muted to comply with the standards.
4 Press ENTER/OK.
5 Press 1 to return to the Audio Setup Page.
16

EQUALIZER (Sound Mode)

The "EQUALIZER" allows you to select from various
preset modes that control the frequency bands of sound
to optimize certain musical styles.
It greatly enhances the excitement and enjoyment of your
favourite music.
1 Press 34 to highlight the "EQUALIZER".
2 Enter its submenu "SOUND MODE" by pressing 2.
3 Press 2.
4 Move the cursor by pressing 34 to highlight the selected
item.
➜ NONE: Play the disc under the original sound effect.
5 Press ENTER/OK.
6 Press 1 to return to the Audio Setup Page.
Note: The sound may be distorted if the selected sound mode
is incompatible with the disc contents.
In that case, select another sound mode or "NONE".
3D (REVERB MODE)
The "3D" can simulate the echoes and frequency
response of some particular places so as to make you
feel like personally on the place. The choices are OFF,
CONCERT, LIVING ROOM, HALL, ARENA, and
CHURCH.
1 Press 34 to highlight the "3D".
2 Enter its submenu "REVERB MODE" by pressing 2.
3 Press 2.
4 Move the cursor by pressing 34 to highlight the selected
item.
➜ OFF: Play the disc under the original sound effect.
5 Press ENTER/OK.
6 Press 1 to return to the Audio Setup Page.