Table of Contents
Advertisement
Available languages
Available languages
English
pack charging mode. This feature ensures maximum battery
pack life.
A cold battery pack may charge at a slower rate than a warm
battery pack.
The hot/cold pack delay will be indicated by the red light(s)
continuing to blink but with the yellow light continuously ON.
Once the battery pack has reached an appropriate temperature,
the yellow light will turn OFF and the charger will resume the
charging procedure.
This charger is equipped with an internal fan. The fan will turn on
automatically when a battery is being charged.
CAUTION: Never operate the charger if the fan does
not operate or if the ventilation slots are blocked.
Do not permit foreign objects to enter the interior of
the charger.
nOTE: To ensure maximum performance and life of lithium‑ion
battery packs, charge the battery pack fully before first use.
1. Plug the charger into an appropriate outlet before inserting
battery pack.
2. To unlock the storage door
handles
3
and lift and move the metal latches
latch pin slot
5
of the storage door.
3. Open the storage door
compartment
and the battery charger
12
4. Slide the battery pack
20
rails
14
, making sure the battery is fully seated. The left or
right side charging light
that the charging process has started.
nOTE: Charging can take place with the storage door
open or closed.
nOTE: To close the storage door
the storage door and use the other hand to lift up and slide
the door brace
16
towards the front of the box.
5. The stage 1 charging blink indicator represents the charge
process that charges the majority of the battery's capacity.
6. The stage 2 charging blink indicator represents the
remainder, or top off charge process, for the battery to reach
full capacity.
7. The completion of charge for stage 1 or stage 2 will be
indicated by the stage's light remaining ON continuously.
8. The battery pack is fully charged when both stage 1 and
stage 2 charging lights remain ON continuously, and it may be
removed and used at this time or left in the charger.
nOTE: To remove the battery pack, some chargers require the
battery pack release button
Indicators
Stage 1 Charging
Stage 2 Charging
Fully Charged
Hot/Cold Pack Delay*
8
, flip up the door latch
2
4
to access the storage
2
.
13
onto the left or right side charger
will blink continuously indicating
6
2
, use one hand to support
19
to be pressed.
* The red light will continue to blink, but a yellow indicator light
will be illuminated during this operation. Once the battery pack
has reached an appropriate temperature, the yellow light will
turn off and the charger will resume the charging procedure.
A charger will not charge a faulty battery pack. The charger
refusing to light could indicate a problem with the charger or a
faulty battery pack.
nOTE: If the charger refuses to light, take the charger and
battery pack to be tested at an authorized service center.
leaving the Battery Pack in the Charger
The charger and battery pack can be left connected with the
charge indicators showing pack charged.
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger from
the AC outlet before cleaning. Dirt and grease may be
removed from the exterior of the charger using a cloth
or soft non‑metallic brush. Do not use water or any
cleaning solutions.
Proper Hand Position (Fig. E)
from the
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Carry Handle (Fig. A)
This charger has a built in carry handle
2
you to carry the charger when not attached to a
ToughSystem® storage box.
Storage Compartment (Fig. F)
WARNING: Avoid overfilling the storage
compartment to prevent any interference with the
batteries being charged.
WARNING: Do not force close the storage door. If the
storage door will not fully close or the door latches will
not lock easily, ensure the storage compartment is not
overfilled. Remove a few items and try closing the storage
door and locking the latches again.
This charger has a built in storage compartment
extra batteries, cords or tools.
1. To unlock the storage door
handles
3
the latch pin slot
2. To access the storage compartment
door
until the door brace
2
3. To close the storage door
storage door
the door brace
4. To lock the storage door
4
to the latch pin slot
and inward on the door latch handles
an audible click. Ensure the door latch handles are securely
held in place.
1
that allows
2
, flip up the door latch
and lift and remove the metal latches
of the storage door.
5
12
locks into position.
16
2
, use one hand to support the
and use the other hand to lift up and slide
2
16
towards the front of the box.
, lift and move the metal latches
2
5
of the storage door. Press down
12
to carry your
4
from
, open the storage
until they make
3
Advertisement
Table of Contents
