Table of Contents
Advertisement
Please retain your proof of purchase for warranty repairs.
Authorized repair service is available at the Foredom factory in Bethel, CT. Send items for repair to the factory marked
"Attention: Repair De part ment". Enclose the item(s), a packing list, daytime phone number, return address, email
address, and information regarding the problem or repairs required. Estimates of repair cost will be made upon request.
It is our policy not to proceed with a repair without your approval if the cost (labor plus parts) is more than fifty percent
of the cost for a new replacement. You will be notified and advised of the cost to repair and to purchase a new replace-
ment.
Complete Kit (Fig. 3)
Control Unit, Power Cord
Brushless Handpiece
Handpiece Holder,
Phillips Screw, Washer
Foot Pedal
Handpiece Cradle
Collet Changing Wrench
AC Power Input (Fig. 4)
1. Check the label on the rear of the Control Unit to
make sure that the electrical specifications match your
AC power.
2a. If the fuse needs to be replaced (Fig. 5), replace it
with identical type and rating only– For 115 V micromo-
tor use a 5x20mm, SLO-BLOW, 3.15A, 250V.
2b. For a 230V Micromotor use a 5x20mm,SLO-BLOW,
1.6A, 250V. The Fuse Holder 16 contains a spare fuse
(Fig. 5).
CAUTION
Never plug or unplug the Power Cord with wet
•
hands to avoid electric shock.
Use only with a grounded AC power receptacle.
•
Installation
CAUTION
The Control Unit should rest on a flat, steady
•
surface. Avoid blocking the ventilation openings in the
bottom of the case (Fig. 6).
Use the Control Unit in locations with a
•
temperature below 100ºF. Avoid excessively dusty, hot
or humid locations.
A Brush Type Handpiece
may be used with Kit
K.1050 but is NOT includ-
ed with this kit
2
16
Advertisement
Table of Contents
