Table of Contents
Advertisement
Disassemblied part
©
Holding plate support
Procedure for disassembly
(2) Remove the holder SP(L) a).
(1) Remove the E-clip (8), , washer
(®, and collar link @), and then,
remove the plate side assembly
block.
(3) Remove the screw (3, and
remove the damper ¢4).
(4) Remove nine rack dampers.
| (5) Remove the two screws (5), ,
and remove the sensor assembly
and sensor cover L 2).
Use care not to distort the
sensor.
Use care not to scratch gear
teeth.
Use care not distort the sensor.
Use care not to stain leaf
switch contacts or not allow
any foreign matter to stick to it.
Use care not to deform the lead
switch.
(1) Remove the holder SP €4).
(2) Remove the E-clip 2. E-clip
, and collar link 80), and
remove the holding plate support
block.
(3) Remove the lock spring @7).
(4) Remove the screw @8), and
remove the leaf switch of the
sensor assembly 3).
(5) Remove the spring (5), and
remove the sensor cover@0) and
the sensor assembly
:
(6) Remove the screw (3),, and
remove the lead opener @2).
€3) Holding plate support
- Use care not to deform the
spring.
(1). Remove the six screws @),,
remove the two cassette holder
supports @) , and remove the
plate holder @).
(2) Remove the screw @),, and
remove the cassette holder
support (4).
@) Plate holder
Assembly
For assembly, reverse the procedure for disassembly.
Always use new E-rings and washers.
79
Advertisement
Table of Contents
