Teac TASCAM DA-P20 Service Manual page 79

Disassembled part
Two reel assemblies
* Use care not io stain the ree!
(1) Remove the two washers 68),.
assembly reflector with grease.
(2) Remove the two reel assemblies
(3) Remove the two luminaries @8).
(4) Remove the two BT springs 67).
(1) Remove the two washers (08).
(2) Remove the TU assemblies (oD.
)
(3) Remove the two polysliders
(1) Remove the three screws 69,
and remove the sensor assembly
qoATU assembly
@02)Sensor assembly
(1) Remove the two washers 08).
(2) Remove the intermediate gear
and worm wheel 414).
(3) Remove the two screws :
and remove the switch assembly
15) Switch assembly
Remove the two washers 69),,
and remove the motor bracket
(18)Motor supporter
(2) Remove the two screws G18),
and remove the motor suporter
10 Center pulley (1) Remove the washer 68),, and
ae . remove the pulley (10.
04D gear ass'y (1) Remove the washer 68,, and
remove the !D gear ass'y .
(2) Remove the sensor SP (03.
* Use care not to scratch gears.
Assembly
For assembly, reverse the procedure for disassembly.
Always use new E-rings and washers.
75