Switching The Afr Function Off - Yamaha Acoustic User Manual

w
If the application of a single band filter does not take care of the feedback, press
the switch as described in step
filters can be set.
* The following display will appear if all 5 filters have been set.
The AFR Function's settings are not saved along with patch data. And the
AFR Function's settings are cancelled when another patch is selected.
CAUTION
Be careful. Constant feedback at loud levels can cause damage to equipment.

Switching the AFR Function OFF

To switch the AFR Function OFF, follow the instructions below and change the setting to "AFR FUNC-
TION OFF". When the AFR Function is switched OFF in a patch that uses the "Acoustic Multi" effect
type, the switch will operate as an effect ON/OFF switch, the same as when used with other effect
types.
q
After pressing the [STORE/EXIT] button, press the AFR/ON/OFF switch two times
to select the "Effect Type Select" display in the Deep Edit Mode.
* When pressing the switch two times, make sure the switch is released within one second both times.
w
Until the following display appears, press and hold (for about four seconds) the
AFR/ON/OFF switch.
The display shown above will appear for one second and then return to the display that was
selected before the [STORE/EXIT] button was pressed.
When "AFR FUNCTION OFF" is set, the " " icon located to the right of the patch number will be
shown, even when a patch that uses the "Acoustic Multi" effect type is selected.
e
To switch the AFR Function ON again, follow steps
once again.
Auto Feedback Reduction (AFR) Function
q
and set a second filter. A maximum of 5 band
q w
and described above
23