Kawai SR5 Owner's Manual page 48

(4) Press the PLAY switch a third time to restart the
playback,
(5) Press the END switch to terminate the playback.
Note:
The LED in the switch goes out to indicate that the
playback function is inactive. Pressing the PLAY
switch again therefore starts the sequence from the
beginning rather than from the point at which you
stopped the playback.
® End of sequence
When the sequencer reaches the end of the sequence,
it checks the status of the REPEAT switch. If the LED in
the swith is on, the sequencer automatically restarts
from the beginning. Otherwise, it stops and turns off
the LED in the PLAY switch. If you are using the
Repeat switch you may terminate the sequence by
either pressing the END switch or pressing the
REPEAT switch and waiting for the sequence to end.
7.4 Editing Functions
lM Replace — Correcting entries
The procedure for correcting sequence entries during
input has already been described above. This editing
procedure is available at all other times as well.
® Procedure
(1) Use the CHORD and REGIST switches to specify
what you wish to edit: chords, registrations, or both.
(2) Press the RECORD switch.
(3) Use the arrow switches to advance to the bar and
beat to be edited.
(4) Press the correct chord, registration, or both, and
then press the right arrow switch to store the new
data.
Note:
Remember that you must hold down a chord, but the
number switch remains activated {with the lamp
inside lit) up until the end of the bar even after you
release it.
a
(5) Turn the RECORD switch off to terminate the
editing session.
Note:
DO NOT PRESS THE END SWITCH. The END switch
signals the end of the sequence, not the end of the
session. Pressing it here will erase all data after the
current bar.
i