Table of Contents
Advertisement
Configuring the
MCso
2-42
A key program can be directed in one of three ways:
• To the terminal (local echo).
• To the terminal and host (remote echo).
• To the setting selected from the Comm Mode parameter (normal echo).
To redefine a key:
1.
Press
F11
to invoke the
Function Keys Setup
menu.
2.
Simultaneously press
Ctr/
with the key to be prograrruned. This highlights
the key's direction and defurition fields.
3.
Press
i
or J- to highlight the shifted or unshifted key definition field (see
Figure 2-13).
4.
Enter the key program (up to 255 characters) at the cursor position. Correct
any errors by backspacing to delete an individual character or press
F14
on
the ANSI or
Home
on the EPC/IEPC keyboards to clear the entire
defurition. Use
the~
or--+ key to position the cursor.
Note:
Control characters can be entered by simultaneously pressing Ctr/ and the
appropriate keys.
If the Funct Key, Compose Key, or Left Alt Key parameter in the Keyboard
Setup Menu has been set to Meta, characters can be entered with the high
bit set. Simultaneously press the
Compose Character
or left
Alt
key with the
appropriate alphanumeric key.
Unless the Funct Key, Compose Key, or Left Alt Key parameter was set to
Meta before you entered setup mode, you must set the parameter to Meta.
Then exit and reenter setup mode to enter the 8-bit characters.
When the Virtual Terminal parameter is set to
On
or Split (dual sessions), different
key programs can be programmed for each session per the instructions outlined
above. To redefine keys in an alternate session, press
Ctr/ Shift
F11.
MCao User's Guide
Advertisement
Table of Contents
