Link MC80 User Manual page 40

Configuring the MCso
2-20
Table 2-5. Communications Setup Menu Parameters
Comm Mode
Full Duplex
Block
Half Duplex
1
Half Block
Local
Printer Port
Parallel
Serial
None
Host Xmt Limit
None
30 cps
60 cps
150 cps
Fkey Xmt Limit
None
30 cps
60 cps
150 cps
Aux Receive
Off
2
On
The terminal's host port communication mode is:
Full-duplex.
Block
Half-duplex
Half-duplex block
Local
During print operations, the MCso will send data to a:
Parallel printer connected to the PARALLEL port.
Serial printer connected to the serial port (SERIAL or
SERIAL 2) not assigned as the host port.
Disabled.
The MCso sends data via the host port:
As fast as the baud rate allows.
At a maximum of 30 characters per second.
At a maximum of 60 characters per second.
At a maximum of 150 characters per second.
The terminal sends function key definitions:
As fast as the baud rate allows.
At a maximum of 30 characters per second.
At a maximum of 60 characters per second.
At a maximum of 150 characters per second.
Data received on the serial port (SERIAL 1 or SERIAL
2) not assigned as host port is:
Ignored.
Sent to the host.
1
Do not select this setting unless it is required. Duplicated characters will appear on the
screen if data is echoed from the host.
2
Must be set to Off for dual sessions (Virtual Terminal set to On or Split).
MCao User's Guide