Installation Procedure - Bosch HMV 8051 U Installation Instructions Manual

Installation procedure
Removing the mou nting Note: To avoid possible damage to the work surface or to the bottom of the
plate appliance, cover the worksurface.
1. Remove any remaining contents from the microwave oven cavity.
2. Remove the screws from the mounting plate.
This plate will be used as the rear wall template and for mounting.
3. Reinstall the screws into the holes where they were removed.
Note: To avoid damage to the microwave oven, do not grip or use the door or door
handle while the microwave oven is being handled.
Finding the wall studs Note: The microwave must be connected to at least one wall stud. If no wall studs
exist within the cabinet opening, do not install the microwave oven.
1. Locate the edges of the wall studs within the cabinet opening by using:
® astud finder or
e ahammer (tapping lightly across the mounting surface to find a solid sound).
2. Place a mark halfway between the edges and draw a line down the center of the
studs (See possible wall studs configuration)
Possible wall stud configurations
These depictions show examples of preferred installation configurations with the
mounting plate.
Note: Care must be taken when drilling holes. Electrical wires may be concealed
behind the wall covering and contact with them could result in electrical shock.
10