Installation Procedure; Removing The Mounting Plate; Finding The Wall Studs; Possible Wall Stud Configurations - Bosch HMV 3051 C Installation Instructions Manual

Hide thumbs Also See for HMV 3051 C:

Table of Contents

Installation procedure

Removing the mounting

plate

Note: To avoid possible damage to the work surface or to the bottom of the

appliance, cover the worksurface.

1. Remove any remaining contents from the microwave oven cavity.

2. Remove the screws from the mounting plate.

This plate will be used as the rear wall template and for mounting.

3. Reinstall the screws into the holes where they were removed.

Note: To avoid damage to the microwave oven, do not grip or use the door or door

handle while the microwave oven is being handled.

Note: The microwave must be connected to at least one wall stud. If no wall studs

exist within the cabinet opening, do not install the microwave oven.

1. Locate the edges of the wall studs within the cabinet opening by using:

a stud finder or

a hammer (tapping lightly across the mounting surface to find a solid sound).

2. Place a mark halfway between the edges and draw a line down the center of the

studs (See possible wall studs configuration)

These depictions show examples of preferred installation configurations with the

mounting plate.

Note: Care must be taken when drilling holes. Electrical wires may be concealed

behind the wall covering and contact with them could result in electrical shock.

Table of Contents

Table of Contents