Table of Contents
Advertisement
INSTALLATION
Gas Information
Adapting the Cooktop for Different Types of Gas
To adapt the cooktop to a different type of gas than that for which it was designed, (see the sticker
under the hob or on the package), the burner nozzles must be changed as follows:
• Conversion must be done by a trained professional.
• Remove the pan supports and slide the burners out of the cooktop.
• Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new type
of gas.
• Reassemble the parts following the instructions in reverse order.
• On completing the operation, replace the old rating label with the one showing the new type of
gas; the sticker is available from our SERVICE CENT RES.
IF THE GAS PRESSURE IS DIFFERENT THAN THAT PRESCRIBED, A PRESSURE
REGULATOR MUST BE INSTALLED AT THE SOURCE, IN COMPLIANCE WITH NATIONAL
STANDARDS GOVERNMENT THE USE OF PIPED GAS REGULATORS.
To complete the conversion, follow up below:
• Replacement of the burner injectors
• Regulation of the burner flame level
• Leak test
Fig. 20
INDUCTION
Advertisement
Table of Contents
