Table of Contents
Advertisement
8695 8594 / D
E - STARTING UP
GENERAL
Upon receipt, make sure that the packaging is not damaged, that the fan has not suffered any impact that would lead to
malfunctioning and that the rotor turns freely with no friction.
The fan must match the required specifications.
The specifications indicated on the motor identification plate must match those of the electrical system (voltage, frequency etc.)
All fans are inspected and tested at the end of manufacturing.
INSTALLATION
Caution! The rotating parts of fans (rotor, shaft, pulleys) are very hazardous.
The fan must be fixed rigidly with the help of bolts and washers, using all the holes provided.
The fan fastening mount must keep the motor shaft perfectly horizontal or vertical, depending on the type of device.
Large fans must be mounted on elastic blocks.
Incorrect fastening of the fastening screws can lead to noise and harmful vibrations.
The fan location must not block the external ventilation of the motor.
Allow a gap of at least 50 mm between the rear of the electric motor and the walls of the room.
The fan support must be adapted for its weight.
Appropriate tools must be used to allow proper fan assembly.
In order to address the main safety requirements, assembly must be carried out by qualified personnel (electro-mechanical
technician).
Once mechanical assembly is complete, make sure that the rotor can turn freely.
The fan inlet and outlet grilles are fitted in the factory to ensure CE conformity of the fan.
The inlet grille also protects the impeller from accidentally taking in cloth, paper or other material that could upset the balance of
the rotor.
If the fan performance drops over time, make sure that the grille is not holding back material blocking off the fan inlet.
FIXED FANS
-10
Advertisement
Table of Contents
