Table of Contents
Advertisement
AXIS M1065-LW Network Camera
About system options
Note
H.264 video streams will not be available if the RTSP server is disabled.
Wireless
Status of wireless networks
To view a list of available wireless networks, go to System Options > Network > Wireless. The status of wireless networks list is the
result of a network scan and provides the following information:
•
SSID is the name of a wireless network.
•
Mode shows the type of network, for example Master (an access point).
•
Security shows the type of security the network uses.
•
Channel shows the wireless channel currently in use.
•
Signal strength shows the quality, the strength, of the signal.
•
Bit rate shows the current bit rate in Mbit/s. This can only be shown for the access point currently in use.
Click Refresh to perform a new scan.
Access points with a disabled SSID Broadcast will not appear unless the Axis product is associated with it. Once the wireless
connection is established, the network the Axis product is currently linked to is shown in blue. A network using unsupported
security is shown in grey.
Wireless Settings
Important
• To establish and maintain communication, all wireless settings must be exactly the same in the Axis product as in the
access point.
• Always configure or change the wireless settings in the Axis product first, before changing the settings in the wireless
access point.
• Keys, passphrases and certificates that are used for security must be entered manually. Contact your Network Administrator
for the requirements for the selected access point.
The wireless settings control how the Axis product interacts with the wireless network. Apart from identifying the wireless network, it
is also possible to enable wireless encryption.
Select Enable congestion control to secure the wireless connection between the Axis product and access point in congested
environments, for example where there are many available networks and where many devices are using the same access point.
Congestion control uses a Request To Send/Clear To Send (RTS/CTS) handshake to reserve access to the wireless media before
transmitting a packet. Using the handshake decreases throughput since it adds an overhead. In some situations, however, the
overhead of the RTS/CTS handshake is lower than the overhead caused by collisions on the wireless media. Congestion control is
disabled by default.
Select Enable WLAN pairing button to allow the wireless Axis product to connect to an access point by pushing a button on both
of the devices within a 120 second time window. During this time the devices will automatically discover each other and agree
on a configuration.
Make sure the access point also has push button configuration (PBC) enabled and that the Axis product is not connected to the wired
network. After a successful pairing any WLAN settings set by the user in the Axis product are overwritten. The WLAN pairing button
is enabled by default; deselect this option to prevent unauthorized WLAN pairing.
SSID is the name of the selected wireless network, which must be exactly the same as the name in the wireless access point. If the
field is left blank the Axis product will not connect to any wireless network.
55
Advertisement
Table of Contents
