Technical Data; Running Time - BorMann PRO BLF3550 Instructions Manual

EN
Important hints
1. Install the lamp:
Install the lamp correctly at the place where the sunlight can reach, and press the switch, the lamp shall be lighting on normally. After two minutes, the lamp will
enter the light sensing mode. If installing during daytime, the lamp shall enter the charging mode without lighting on, and the indicator light shall flash or be on
green.If installing at night. the lamp shall continue to light on after two minutes, and the indicator light shall be on normally until the automatic charging and dis-
charging cycle after daylight.
2. Indicator light:
Red light indicates lack of current and needs to be charged urgently; yellow light indicates that the current is below 70%, indicating that it can be charged; the
green light indicates that the power is sufficient.
3. It supports external power supply and solar panel expansion charging. Solar lamps are often unable to display due to no sunlight in the room or lack of power
and no light during indoor display. This lamp can support adapter or solar panel expansion charging < 5V 0,1.- 3A.
Other hints
1.Please do not connect 220 V AC to avoid damaging solar lights!
2.Please pay attention to fixing the solar panels and lamps so as not to hurt people when the wind blows.
3.Please do not disassemble the solar energy lamp, so as not to affect maintenance.
4.ln order not to affect the use of lights, dean up the dust and dirt on the surface of the solar panels every 3 months.
5.Solar powered lamps contain batteries.
6. Batteries are recyclables. Please do not litter.
7 .The battery must be fully charged before It can be used for more than 12 hours.
MODEL
RATED POWER
COLOUR TEMPERATURE
COLOUR RENDERING INDEX
BATTERY CAPACITY
CHARGING TIME

RUNNING TIME

DIMENSIONS
BEAM ANGLE
MATERIAL
IP GRADE
AVERAGE LIFE (HRS)
LUMINOUS FLUX
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect
the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the
manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjust-
ments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The
manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
3

TECHNICAL DATA

BLF3550
150 W
6500 K
> 70
32650 - 10000 mAh
6 hours
12 hours
500*235*80 mm
120°
ABS
IP65
25000
750 Lumen
WWW.NIKOLAOUTOOLS.COM
BLF3600
300 W
6500 K
> 70
32650 - 20000 mAh
6 hours
12 hours
820*245*75 mm
120°
ABS
IP65
25000
1000 Lumen
SOLAR STREET LIGHT LED WITH SOLAR
PANEL EMBEDDED, WATERPROOF