Intended Use; Inserting/Replacing The Battery - Bosch GLL 30 Operating/Safety Instructions Manual

internal wires may be misplaced or pinched or may be improperly
mounted. Certain cleaning agents such as gasoline, carbon
tetrachloride, ammonia, etc. may damage plastic parts.
The tool is intended for determining and checking horizontal and
vertical lines. The measuring tool is suitable exclusively for operation in
enclosed working sites.
Use only alkaline batteries.
To open the battery lid 4, press the latch of the battery lid 3 and fold the
battery lid up. Insert the supplied batteries.
When inserting, pay attention to the correct polarity according to the
representation on the inside of the battery compartment.
When the batteries are low, the laser beams flash 0.10 s off, 0.20 s on,
0.10 s off, 1.0 s on in a cycle.
Always replace all batteries at the same time. Only use batteries from
one brand and with the identical capacity.
WARNING
!
extended periods, the batteries can corrode and discharge themselves.
SAVE THESE INSTRUCTIONS.

Intended Use

Preparation

Inserting/Replacing the Battery

Remove the batteries from the tool when not
using it for extended periods. When storing for
-9-