Yamaha NS-P300 Owner's Manual page 11

To connect the subwoofer to line output (pin jack) terminals of the amplifier
Connect the main speakers to the speaker output terminals of the amplifier.
• To connect with a YAMAHA DSP amplifier (or AV receiver),
connect the LOW PASS (or SUBWOOFER etc.) terminal on
the rear of the DSP amplifier (or AV receiver) to either the
left (L) or right (R) INPUT2 terminal of the subwoofer.
Main speaker
Left
Amplifier
Notes
• Some amplifiers have line output terminals labeled PRE
OUT. When you connect the subwoofer to the PRE OUT
terminals of the amplifier, make sure that the amplifier has
at least two sets of PRE OUT terminals. If the amplifier has
only one set of PRE OUT terminals, do not connect the
subwoofer to the PRE OUT terminals. Connect the
subwoofer to the speaker output terminls of the amplifier.
(Refer to pages 8 and 10.)
Subwoofer
OUTPUT
TO SPEAKERS
INPUT2
INPUT1
FROM AMPLIFIER
INPUT2
HIGH
AUTO
VOLUME LOW
STANDBY
OFF
0 10
STANDBY-RED
HIGH
ON-GREEN
HIGH CUT
LOW
POWER
ON
OFF
To AC outlet
• To connect the subwoofer to the SPLIT SUBWOOFER
terminals on the rear of the DSP amplifier, connect them to
both of the left (L) and right (R) INPUT2 terminals of the
subwoofer.
Pin plug cords
LOW PASS
(SUBWOOFER)
SPLIT SUBWOOFER
• When connecting to a monaural line output terminal of the
amplifier, connect to either the left or right INPUT2 terminal.
• When connected to line output terminals of the amplifier,
other speakers should not be connected to the OUTPUT
terminals on the rear panel of the subwoofer. If connected,
they will not produce sound.
Main speaker
Right
11