Table of Contents
Advertisement
Recording Your Performance (Phrase Recording)
You can record your performance as User Song (Song number 123), which can then be played back on the instrument. The
recorded User Song can be played back in the same way as the preset Songs.
• A total of approximately 300 notes can be recorded to the User Song.
1
Select the desired Voice.
2
Press [PHRASE REC] y to enable the Record mode.
"UserSong" will be shown on the display.
UserSong
To exit the Record mode, press [PHRASE REC] y again. (The
flashing bars will stop.)
NOTICE
• If a User Song has already been recorded, overwrite
recording will be enabled (erasing the already recorded
user song data and recording a new one).
3
Play the keyboard to start recording.
NOTICE
• Never attempt to turn the power off or to connect or
disconnect the AC adaptor during recording. Doing so can
result in a loss of data.
• If the recording capacity becomes full during recording,
"Mem Full" will appear on the display, recording will end,
and the Song select display will appear.
• Recording will also start if you press [START/STOP] !1
without playing the keyboard.
Limitations while recording:
• The following settings/operations cannot be recorded: Reverb
Level, Style, metronome click, Transpose, Tuning.
• The following settings and buttons are not available, or if
operated, new settings cannot be recorded:
Split Point, Reverb Type, Chorus Type, [FUNCTION] !6 ,
[PORTABLE GRAND] !8 .
4
Press [START/STOP] !1 to stop recording.
5
Press [START/STOP] !1 to start playing the recorded
song.
You can also play by selecting [USER] from the Category
buttons !4 in Song selection (page 18).
• User Song data can be erased by overwriting empty data.
To do this, enable the Record mode in step 2, and then
press [START/STOP] !1 twice in succession.
The bars will flash.
PSR-E283 YPT-280 Reference Manual
29
Advertisement
Table of Contents
