Table of Contents
Advertisement
TAPE DUBBING
1. Insert a blank tape into a cassette deck 2 (TAPE2).
2. Insert a recorded tape into a cassette deck 1 (TAPE).
3. Select the input function of TAPE2 MON to monitor the sound. (See No. @ on page 10)
4. Set the cassette deck 2 to recording mode.
5. Set the cassette deck 1 to playback mode.
Dubbing will start.
NOTE: If you press the TEST TONE button during TAPE RECORDING or TAPE DUBBING, the audio
signal is not recorded.
PROTECTION CIRCUITS
This receiver has special protection circuits.
© The thermal overload protection circuit automatically turns off the power if it begins to overheat.
e The overdrive protection circuit automatically turns off the power if it is about to deliver too much power.
e The short protection circuit automatically turns off the power if the speaker terminals are shorted.
If the receiver turns off, check to be sure that the ventilation holes on the top of the receiver are clear of
obstructions, and check the speaker connections and impedance.
ENGLISH
Advertisement
Table of Contents
