Advertisement
Place the speaker precisely between the rear speakers as
shown in the figure below.
Main R
Center
Main L
Rear L
I To mount the speaker on a wall by using
the provided mounting bracket
1
Attach the bracket to the rear of the speaker by using the
provided screws. Remove the provided pads from the
backing sheet and put them at the lower corners of the
speaker.
2
E-
PLACING THE SPEAKER
Subwoofer
Rear R
NS-10MMTS
Mounting bracket
Screw
Pad
2
Fasten screws into a firm wall or wall support as shown
in the figure, and hang the holes of the mounting
bracket on the protruding screws.
* Make sure that the screws are securely caught by the
narrow parts of the holes.
Wall/ wall
support
You can also use the screw holes on the bottom of the
speaker for installing the speaker on commericially
available speaker stand (if you do not use the provided
mounting bracket.)
60 mm
A screw with a diameter of 4 mm can be
used.
(Hole depth : 10 mm)
WARNING
● This speaker weighs 1.5 kg (3 lbs. 5 oz.). Do not
mount it on thin plywood or a wall with soft surface
material. If mounted, the screws may come out of the
flimsy surface and the speaker may fall. This
damages the speaker or causes personal injury.
● Do not install the speaker to a wall with nails,
adhesives, or any other unstable hardware. Long-
term use and vibrations may cause it to fall.
● To avoid accidents resulting from tripping over loose
speaker cable, fix it to the wall.
● This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color. Should this
happen, move the speaker away from the TV set.
Tapping screw (3.5–4 mm)
(Available at the hardware
store)
Min.
20 mm
3 mm
40 mm
Advertisement
