Advertisement
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
• After removing the two buttons remove the 4 screws
at the back and the 5 screws
housing (see pictures).
• Screw
D
at the front does not need to be removed, this
screw is for ESD and is located in the lower housing.
B
B
C
C
• To replace the potmeter (9) situated at the bottom
of the upper housing, remove knob (7) on top of the
upperhousing and remove the 2 scews
of the upper housing (see picture).
E
C
at the front of the upper
B
C
C
D
C
E
at the bottom
E
• After removing the upperhousing, Hose connection (10)
B
and Bucket inlet sealing (13) are accessible. To replace
the hose connection screw
B
• To replace Cordwinder (24) or Motor (31) Motor housing
(28) has to be removed, this can be done by removing
the 4 screws
Remark:
A special long screw driver is needed!
• To replace the PCB (9) remove the 2 short screws H.
FC9723/09
F
has to be removed.
F
G
(see picture).
G
H
G
G
H
G
4-11
Advertisement
