Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sync Ergonomics AEROBAR ONE
Summary of Contents for Sync Ergonomics AEROBAR ONE
- Page 1 AEROBAR ONE GENERAL ASSEMBLY INSTRUCTIONS pg. 1...
- Page 2 Sync Ergonomics components. WARNING: In order to be installed correctly the components of Aerobar One require specialised knowledge of a time trial bicycle. It is recommended that installation should be performed by a qualified bicycle mechanic. Improper assembly of any of the components of Aerobar One could cause damage to the product(s) and/or bicycle, may lead to loss of control of the bicycle, and may lead to personal injury, or in severe cases even death.
- Page 3 If in doubt, ensure assembly is handled by a qualified and experienced bicycle mechanic. AERONABR ONE ASSEMBLY Aerobar One (AB01) is designed to function using the original base bar and extension clamp assemblies relevant to your time trial bike. Please ensure that your bicycle is suitable for Aerobar One prior to installation.
- Page 4 AEROBAR ONE BOM pg. 4...
- Page 5 AEROBAR ONE ASSEMBLY pg. 5...
- Page 6 EXTENSION SETUP OPTIONS Thanks to the unique 3D bend profile, Aero One extensions can be configured with the grip end angled in, or aligned straight. A bike with a narrow extension tube spacing will favor the “angled in” orientation. A bike with a wide extension tube spacing will favor the “aligned straight”...
- Page 7 NOTES ON WIRING AEROBAR ONE Ensure that you complete proper setup of your Aerobar One prior to installing shift wiring. Shimano Di2 SW-R9160 or SRAM Clics - you can run the wires through the extension directly into the shifter. Older Di2 or SRAM Blips...
- Page 8 AEROBAR ONE UCI COMPLIANCE CHECK CATEGORY X SADDLE OFFSET - 0-50 MM LENGTH ALLOWED – 750 MM HEIGHT ALLOWED – 100 MM CATEGORY 1 ATHLETE HEIGHT - <180 CM TALL SADDLE OFFSET - =/>50 MM LENGTH ALLOWED – 800 MM HEIGHT ALLOWED –...
Need help?
Do you have a question about the AEROBAR ONE and is the answer not in the manual?
Questions and answers