Subscribe to Our Youtube Channel
Related Manuals for Sync Ergonomics PROJECT 0.2
Summary of Contents for Sync Ergonomics PROJECT 0.2
- Page 2 Improper assembly of any of the components of Project 0.2 could cause damage to the product(s) and/or bicycle, may lead to loss of control of the bicycle, and may lead to personal injury, or in severe cases even death. Sync Ergonomics assumes no responsibility for improper assembly and installation of the product(s).
- Page 3 WARNING: Do not attempt to modify your Sync components, outside of what is described within this setup guide as appropriate for assembly. Modification may impact the structural integrity of a components and could result in component failure, or failure of the complete system. Sync Ergonomics is not liable...
- Page 4 Part No. Part Name SYN-OPT-WG-M5/M6-LX Left 15 Degree Wedge M5/M6 SYN-OPT-WG-M5/M6-RX Right 15 Degree Wedge M5/M6 SYN-OPT-EX-395-40-RX High Rise Extension (R) SYN-OPT-EX-395-40-LX High Rise Extension (L) SYN-EVO-CP-15-14-CB V2 Deep Groove Arm Cup SYN-OPT-PD EVA Foam Pad M5 x 10mm or M6 x 8mm Torx Button Head Screws (M5 vs M6 Wedges) M5 x 10mm Torx Flanged Button Screw M5 x 10mm Torx Flanged Button Screw...
- Page 5 Arm Cup Wedges mount to the original arm cup mounting points, using the supplied M5 (T25) or M6 (T30) button head Torx screws. We recommend the use of MOTOREX Bike Grease for hardware (screws) used with our Arm Cup Wedges. For Model Year (MY) 2018 (and prior) Speedmax CF SLX, use M6 wedges and the original arm cup mounting screws (shoulder screws).
- Page 6 When removing and installing arm cup pads, working from the sides makes it easier to centralise the pad and ensures the pad remains crease free. Replacement arm cup pads are available from the Sync Ergonomics online store.
- Page 7 The length/height of the extension (with shifters installed) must not exceed the original length/height of the supplied extension. Sync Ergonomics is not liable for product damage and/or personal injury resulting from untrimmed extensions. The correct length and height needs to be set for the athlete in question.
- Page 8 Ensure that the extensions clamps are free of sharp edges that may cause tube damage to the extensions when clamped, and/or when in use. Sync Ergonomics is not liable for product damage and/or personal injury resulting from inappropriately prepared clamping area.
- Page 9 Ensure that you complete proper setup of your Project 0.2 Ecosystem prior to installing shift wiring. You can run the wires through the extension directly into the shifter. When shifters require an external wire, use the pre-drilled hole in the grip end of the extension.
- Page 10 Saddle offset 0-50 mm behind the bottom bracket Saddle offset 50 mm (or more) behind the bottom bracket Athlete height of 190 cm or taller, with a saddle offset of 50 mm (or more) behind the bottom bracket The clamp end of the extension must be trimmed in order to achieve UCI compliance for length.
Need help?
Do you have a question about the PROJECT 0.2 and is the answer not in the manual?
Questions and answers