Philips CMQ405 - annexe 1 Manual page 5

i
• Light in green when the amplifier is
switched on.
• Light in red when the amplifier is
abnormal and protected.
j
• Connect to speakers or subwoofers.
k
l
• To connect +12V-DC power wire,
ground wire, and remote control wire.
6
•
Follow all mounting and wiring instructions.
You can mount the amplifier either under a seat
or on the rear tray.
•
To avoid interference, do not place the
amplifier too close to the car audio or antenna.
•
The supplied mounting screws are 25mm long.
Make sure that the mounting board is thicker
than 25mm.
Place the unit on the location for
installation.
Mark the positions of the four screw
holes.
Drill the holes with driller of
approximately 4mm in diameter.
Mount the unit with the supplied screws.