HP 64000 Reference Manual page 60

SYSTEM OVERVIEW MANUAL
Emulator
Pod
1
Emulation Bus
Memory Bus - ........
PROM Programmer
Bus
Tape Transport Bus
(under PROM Bus)
Rear Panel Bus
Figure 2-25. Bus Configuration
MODEL 64000
.'"'---- I/O Bus
The I/O bus requires connection between the I/O (slot A) card and CPU card (slot C). The
connection is made with a ribbon cable on the top right-hand connector of each card. If the
tape controller card is in the system the top right-hand connector must be connected to the
I/O bus. This may require a different cable than is in the development station. Figure 2-26
shows the cables in the HP Model 52150A cable kit.
2-50