Philips CEM2000 - annexe 1 User Manual page 12

a
g
2
Cut off the bigger end of the supplied
standard connector.
3
Check the car's wiring carefully and
connect them to the supplied standard
connector.
1 Green/black strip Left speaker
2 White/black strip Left speaker
3 Gray/black strip
4 Purple/black strip Right speaker
e RED
f BLUE
g BLACK
h YELLOW To the +12V car battery
4
Connect the supplied standard connector
to the unit.
12 EN
a a
b
c
d
b
b
c
d
e
c
f
h
d
(Rear)
(Front)
Right speaker
(Front)
(Rear)
Ignition key +12V DC
when ON/ACC
Motor/electric antenna
relay control lead/
Amplifier relay control
lead
Ground
which is energized at all
times
a
b
c
d
Tip
•
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Be
sure to make proper connections to prevent
damage to the unit.
Mount into the dashboard
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
3
Remove the two screws on the top of the
unit.